Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Colleyville Owner’s Guide

Ghost Controls keypad and intercom repair in Colleyville typically runs $220 to $460 installed, parts included, and most jobs are completed in a single visit. We stock Ghost Controls keypads and intercom parts on our trucks, so when a keypad goes dead or an intercom stops talking back, we don’t need to order parts and schedule a follow-up. The way most Colleyville homeowners discover the failure is quiet at first: the keypad beeps but the gate doesn’t move, or the intercom rings the house but the voice sounds like it’s underwater. Then one morning it’s simply dead.

Call (817) 242-5426

Ironworks Gate Co. is an independent gate service company, not affiliated with Ghost Controls. What that means for you is simpler than it sounds: we answer the phone, we know the product line, and we don’t need to transfer you anywhere.

Key takeaways:

• Most Ghost Controls keypad and intercom repairs in Colleyville are one-visit jobs
• We stock Ghost Controls parts on the truck and quote the full price before work begins
• Every repair is covered by our written 90-Day Done Right Promise

Which Ghost Controls Models This Applies To

Ghost Controls runs two main keypad lines that we see in Colleyville driveways. The AXDP wireless keypad is the workhorse, a battery-powered unit that pairs to your Ghost Controls opener without running new wire through brick or stone columns. The wired AXDP2 and the intercom-capable keypads show up on newer installations, especially on Colleyville properties where the gate sits more than 50 feet from the house and a wireless signal gets unreliable through limestone and oak canopy.

Here’s the compatibility gotcha most owners hit: Ghost Controls changed their keypad pairing protocol between early and later generation boards. A keypad bought in 2016 will not always pair with a 2023 control board even if both say Ghost Controls on the label. We verify board revision before we quote a replacement, because installing the right part the first time costs less than returning the wrong one. On the intercom side, Ghost Controls uses a two-wire audio system, and the failure is almost never the wire itself in Colleyville. It’s the outdoor speaker cone, which does not survive North Texas summers and winters the way the manufacturer hoped it would.

For OEM versus aftermarket: we install genuine Ghost Controls parts when the model calls for it, because the wireless keypad encryption handshake is proprietary and aftermarket units sometimes drop offline in cold weather. For the wired intercom handset and speaker, quality aftermarket equivalents perform fine and cost less, and we’ll tell you the difference before you spend a dollar.

Signs Your Ghost Controls Keypad & Intercom Is Failing

• Keypad lights up but gate doesn’t respond. The keypad’s transmitter is sending a stale or corrupted code. The fix is usually a re-pair or a new keypad, not a new opener, but it takes a Ghost Controls-compatible diagnostic routine to confirm which one.
• You have to press buttons twice, or harder than you used to. The membrane on older Ghost Controls keypads delaminates in Colleyville heat, especially on south-facing brick columns. Once the membrane lifts, moisture gets behind the buttons and the contacts corrode from inside.
• Works fine in the morning, dead by mid-afternoon. Direct sun on a black keypad housing pushes internal temperatures past 140 degrees in a Colleyville summer. The circuit board flexes and the solder joints crack. We see this on west-facing gate posts more than any other single failure.
• Intercom hums or buzzes but you can’t make out the voice. That’s the outdoor speaker cone, usually rotted at the surround after a few seasons of humidity swings. Sometimes it’s a failing capacitor on the intercom board, but the speaker bearings go first on Ghost Controls units.
• Gate opens on its own, or won’t close, and only when the keypad is connected. A waterlogged keypad can short the data line and send phantom signals. In Colleyville, this shows up most after a hard freeze-thaw cycle in January or February, when micro-cracks in the housing finally let water through.

Replacement Cost & What’s Included

Here’s where Colleyville pricing lands for Ghost Controls keypad and intercom work:

You’ll know the full price before we turn a single screw. We quote parts and labor together, in writing, and the number on the quote is the number on the invoice. If the job turns out to be smaller than we quoted, the bill goes down, not up. Every Ghost Controls repair we complete in Colleyville carries our 90-Day Done Right Promise: if it is not right, we come back and make it right, no paperwork, no arguing.

If you have a written estimate from another company, bring it to us for a free second opinion. And if your repair runs over $250, we’ll take $50 off. Those offers stand on top of each other.

DIY or Call Us?

There are two things you can safely check before calling. First, replace the battery in a wireless keypad with a fresh 9-volt from a brand you trust. Second, look at the keypad housing for cracks, lifting membranes, or water spots. If the housing is cracked, no battery will save it.

What we would not recommend is opening the keypad or intercom unit and probing the board. Ghost Controls keypads are low-voltage, so the danger isn’t shock. The danger is that the pairing routine is sequence-sensitive, and once an owner accidentally wipes the programming, the gate either won’t open at all or will stay open, which is worse. We have also watched a well-meaning homeowner drill a new mounting hole through the harness on a wired keypad, turning a $150 part into a $400 repair. Some things are worth handing off. Call us at (817) 242-5426 and we’ll be out the day you call, with the right part on the truck.

FAQs